Jeg har forresten denne guide til hvordan man efter sigende skulle kunne tilpasse en universel controller.
This controller comes with the most common
wiring connections found on electric scooters. However, depending on your make
and model, you may need to cut and splice a few but not all of the
wires.
Compatible on most 24 Volt products equipped with 180-500 Watt
motors.
Controller connections as follows:
Battery
Connector (Black & Red Wires, Thick)
Battery wiring. Black to Black,
Red to Red.
Motor Connector (Blue & White Wires,
Thick)
Motor wiring. Blue (controller) to Blue (existing wiring), White
(controller) to White/Yellow/Brown (existing wiring).
Charge Connector
(Black and Red Wires, Thin)
Battery charger connector. Black to Black,
Red to Red.
Derailler Connector (Red, Black, & Blue Wires,
Thin)
Hand throttle connector, 3-wire. Plug your 3-wire hand throttle
wires into the three prongs on this connector. Your product's throttle wiring
may be included in an existing 6 pin connector on your wiring harness. Black to
Black, Red to Red, Blue to the third wire on your hand throttle (Blue or Green
or other).
Lock Connector (Blue & Red Wires, Thin)
Key
switch connector. Connect to your product's "lock" connector, or hard wire to
your keyswitch wiring. Wire color connection not critical, but Blue to Blue, Red
to Red if they match.
Brake Connector (Black & Yellow Wires,
Thin)
Brake connector. Your product's brake wires may be included in an
existing 6 pin connector on your wiring harness. Black to Black/Red and Yellow
to Yellow.
Brake Signal Connector (Black & Red Wires,
Thin)
Brake light connector. Black to Black, Red to Red.
Lås og bremsesignal findes ikke på vores nuværende løbehjul.
Måske kan det give en idé om hvad der skal til? Det skulle ikke være forfærdeligt svært - jeg kan bare ikke finde ud af det.....
Hilsen Morten
Bliv gratis medlem
Opret bruger